The Auto Reset Controller provides an audible and visual warning if any detector units sense tobacco smoke and then automatically resets the alarm condition after 30 seconds. The slave detectors are connected to each of the five zones with a maximum of 5 slave detectors on each zone. The Controller allows each zone of slave detectors to be monitored from a remote location without any sound or voice alerts in the protected area. The Controller has a dual LED for each detector, RED for alarm and YELLOW for fault. Additionally, there is a green LED which pulses to indicate power supply healthy, and a general fault (yellow) LED which indicates system fault or low battery. Audible confirmation is facilitated by means of the integral buzzer, which provides a beep at each event. The controller may be battery operated by inserting 4 x ‘D’ type cells into the controller enclosure. Alternatively, an auxiliary power supply (CSA-246) may be used.

For covert monitoring, the Controller is connected to slave units. As part of a master/slave system, the Controller may be connected to a Master Unit by using the optional Output Board (CSA-DBD).

Requires batteries. Can also be powered by CSA-246.

SPECIFICATIONS

Power type	4x,5V alkaline batteries D Can be powered by CSA-246
Operating Voltage	6 V DC
Alarm	Audible and visual
Operating temperature	-10°C to 50°C
Humidity range	0 to 95% non condensing
Instillation position	Wall
Product dimensions	195 x 70 x 115mm
Product weight	430g
Approvals	CE